Based on a simple shooter board styled squaring jig, this wonderful implementation of the Built-It System components offers much more than just 90 degree cutoff control. The T-Track Plus and user made stop positioner provide repeatable crosscut length control. The rear mounted T-Track Regular combined with
a pair of Build-It Brackets along with the twin T-Slot Panel Connectors allow for unlimited adjustment of
the fence angle. And the locking drop panel safely catches any off cuts from your workpiece.

Begin by adding a Miter Slider to a small Build-It Panel. Place in your table saw’s miter slot and adjust
for a good fit, then add a T-Slot Panel Connector to each edge. Increase the platform width away from
the blade by adding another Build-It Panel. Add a large Build-It Panel to the opposite edge. Trim to the blade and then use the remaining piece of the large panel along with another Miter Slider to make the
drop panel as described in Steps 3 through 7 shown on the reverse side of your Build-It Panel’s wrapper.
Make the 24” fence and stop as shown in Fig. 3 and Detail 3A using 24” T-Track Regular and T-Track
Plus components then attach to the T-Slot Panel Connectors using a pair of Built-It Brackets. Lock the drop panel adjacent to the saw blade to catch the off cuts, adjust the fence angle to suit your project
and cut away.